Articles in this section

Insert Vertices from Points

Command Description

The Insert Vertices from Points command enables you to select points and lines to create new vertices (and, optionally, points) along the selected lines. Depending on the mode chosen, new vertices are either created on the line perpendicular to the selected points, or the line is moved to pass through the selected points. 

  • Click in the Points and lines selection field and then in a graphic view select all the points and lines which you want to use to create the new nodes on the closest line. Click Options for additional selection options.
  • Use the Max offset box to limit the search distance from each line within which points will be considered. Each point is used only once and is applied to the nearest line within the specified offset.
  • Select the Mode to use:
    • Insert – This creates new nodes on the line perpendicular to the points selected without moving the line position.
    • Move – This creates new nodes on the line by moving the line onto the points selected.
  • If using the “Insert” mode, choose from 3 options.
    • Tick the None box if all you want are new nodes on the line.
    • Tick the Create box if you want new points created on each new node on the line.
    • Tick the Move box if you want the original points moved onto each new node on the line.
  • If the linestring contains “Vertical Tab” data then you need to tick the Convert to horizontal linestring box to convert that data to be used.
  • Click Apply to apply the changes and keep the Insert Vertices From Points command pane open.

Note: This command only works on Linestrings.

Was this article helpful?
0 out of 0 found this helpful