Loading Data onto Machines

GCS900 Machines

Note: the machine will only recognise files in the below structure. Ensure ZIP files have been unzipped before placing on USB. (Do not use an Apple Mac)

1. Create a folder name “Machine Control Data”.
2. Open the Machine Control Data folder and create another folder called “All”.
3. Place the machine control design folder that was exported from TBC in the steps described above in the “All” folder.
4. Place the “Machine Control Data” folder onto a USB and plug it into the machine.

An Instructional Video can be found here.

SCS900 and Siteworks Controllers

Note: Ensure ZIP files have been unzipped before loading onto the controller. (Do not use an Apple Mac)

To load SCS900 and Siteworks data onto a controller with Windows software:

1. Navigate to the file explorer on the device. On the main hard drive (C: drive) open the folder named “Trimble Synchronizer Data”.
2. Open the folder named after the controller e.g. “PC”, then open the folder called “Trimble SCS900 Data”.
3. Save the SCS900 data created using the steps above in the “Trimble SCS900 Data” folder.

Earthworks Machines

Note: the machine will only recognise files in the below structure. Ensure ZIP files have been unzipped before placing on USB. (Do not use an Apple Mac)

To load Trimble Earthworks data onto a machine:

1. Place the “ProjectLibrary” file that was created when exporting Earthworks data onto a USB.
2. The machine will recognise any Earthworks data saved in the “ProjectLibrary” folder.